reel alpha

Does anyone run both low and high diver wire rods or if I'm the only one? Wondering if anyone else does and if so what lengths? I run 9' for low and 10' for high. Thanks for the input

Wow, interesting. I guess ill.install a resistor and hope.for the best. Thx

Would this happen all of the sudden? Boat ran fine first 2 years I've had it? No resistors on either engine. Port runs fine, starboard has the issues

It's not water when you're running 2 engines off the same tank and one engine is fine while the other can't get over 3k rpm

Awesome, guess I'll try that

Let.me.know how that goes.

I'm having the same problem. No anti siphon valve near my gas tank though. Have changed fuel filter/water separator's 3 times. Changed coil. Changed cap, contacts, confenser, plugs, wires. Switched carbs between both engines. Same engine still gives me ****. Under power no problem until 3000 rpm then fouls out unless I can throw it into neutral. If/when I get mine figured out, I'll post the resolution.e

5-7 85-110' 1 coho rest were kings. Wire diver 90' rigger 40' 2 full cores. Flounder pounder on wire diver, salmon Viagra on rigger and full core.

7-8 this am 100-130 anything green or yellow good luck

What does it take to be a licensed capt?

Thanks for the report

I'm at b-10

I slip at Great Lakes marina on Muskegon lake. The public launch to the west of our marina has good quick depth. You should be able to launch from their no problem.

Was able to get out with the family for 2 hours. Set up in 180 trolled west to 260. Turned back east and bumped a 2yr old king in 220 on a rigger set at 180 on a monkey puke stinger.

Which port were you fishing out of? Kind of water were you running in?

Hopefully getting out of Muskegon tomorrow. Any ideas on where to setup?

Have been out of Muskegon and Grand Haven the past 2 days with no results? Anyone have a clue where the fish are??

Where did you find them?

Email me at [email protected]. I can help you out James