Jump to content
Sign in to follow this  
GLF

Engine Idle Speed Adjustment(Boat-In-The-Water) Mercury I/O

Recommended Posts

Warning

DO NOT leave helm unattended while performing idle speed adjustment. Boat MUST BE moving forward (not tied to the dock) when setting idle speed.

Engine should idle at 650-700 RPM with boat in the water, drive unit in forward gear and engine at normal operating temperature. If idle speed is incorrect, proceed as follows:

1. Disconnect throttle cable from carburetor. Be careful not to lose spacer on anchor stud and spacer and bushing on throttle lever screw.

2. Start engine and place remote control lever(s) in forward gear, idle position. Adjust idle speed adjustment screw to obtain recommended RPM.

Caution

Throttle cable brass barrel MUST BE adjusted properly (in next step). Over-adjusting barrel in the other direction will exert excessive pressure on throttle lever, which could cause damage to carburetor linkages.

3. Stop engine. Readjust cable brass barrel (to compensate for throttle lever movement) and reinstall throttle cable. Be sure to tighten attaching nuts.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×